Information on how to pump a well with one’s own hands is very popular. The fact is that the work associated with water supply is quite expensive in itself, and if you also pay for professional pumping, the amount will prove to be indecent.

Traditionally, pumping (or pumping) is a procedure in which a well is cleaned after drilling and prepared for further operations. This is due to the fact that immediately after the work in the selected cavity, a completely non-crystalline liquid appears.

The raised water contains a large number of suspended particles and only with special operations their content can be reduced to an acceptable level. Equipment selection Any instructions for self-preparation of a water well for operation begin with a description of the equipment used.

Our article will not be an exception: A high quality well pump is required to supply water for domestic use. In principle, it can be used for our task, but the high price of such equipment makes such an approach unreasonable. Passing through the water suspension of solid parts, if the device does not break, it will be consumed a lot, and at the beginning of the operation it will be practically unsuitable for the job.

Low cost submersible pump: what we need The best way to get out of this situation would be to buy an economical submersible pump specifically for pumping. Of course, in the process of cleaning a well an economic model will stick a couple of times, but it will take care of the main task. be careful! On clay soils, you may need at least two devices: one pump performs an accumulation, the second is under repair. By choosing which pump to pump the well, it is worth dwelling on the use of centrifugal device types. The fact is that vibration models with such a load can work for very short periods,

so they will have to be changed often, and this is clearly an extra cost. Installation of the pumping system In order for the creation process to proceed as efficiently as possible, our pump must be properly suspended: The device is located at a distance of about half a meter from the bottom of the well (this usually coincides with the level of a gravel filter). To hang, use a special cable or halyard mounted on a shock absorber consisting of a durable rubber cord. Pump positioning scheme Tip: During work there is a risk of the pump entering the oozy layer.

It is to pull the device locked and we need a very strong suspension. In the process of operation, the pump should actively capture silt particles from the lower layer. If this does not happen, the installation position must be adjusted. To prevent the equipment from breaking less frequently, we periodically extract the device and wash all the moving parts under running water, removing the accumulated clay particles. Obviously, this will reduce the working speed, but it will be possible to save on the purchase of a new pump instead of a burnt one.